Amplified RX Loop Test and a Little Outdoor Antenna Work.

 This week end I have been active with antenna work.

Small Receiving Loop.

The first was a test using a low cost Chinese amplifier for the NCPL (loop).

The amplifier is actually "overkill", stated gain/bandwidth is 32dB/1-2000MHz. Not surprising, the gain is too high, both attenuators are in action on the FRG-100 receiver, and the base noise level (not interference), especially on 5-10MHz, is still very high.

Considering that the antenna is till tested indoors in the noise field I would expect things to improve when the antenna (properly weather proofed) is placed outdoors, but there is still one problem. The high gain causes intermodulation, maybe also cross modulation. I have not tested this, but in addition it is possible that the amplifier is oscillating in the UHF range. 

Which signals cause the intermod etc? I suspect it can be the MW broadcast band, but given the bandwith/gain of the amplifier it could be FM broadcast stations, too.

As I suspected this type of amplifier is simply unsuitable for such low frequencies, but I had to test it.

A simple 2 transistor with negative feedback is in my thoughts, along with a pre-selector. N1KPR has published a simple design that could be made on simple perf-board. 

Outdoor antennas.

The weather was pleasantly warm today, so a little outdoor antenna work was done. Since I do it all alone things may take a bit longer.

First outdoor thing was removing the lowered 6m half wave vertical antenna. There was a bit of rust, so the WD-40 was in action. This antenna was mounted on a satellite dish mount on the lawn, so this is now freed for other antennas. In addition, the cable was freed as well, and put to good use.

The 5 band dipole (10-15-20-40-80) had been connected together with the 4m vertical (now partly lowered) with a HF/VHF diplexer, which this was removed. The dipole is now connected to the old 6m antenna cable. Testing from indoors, the dipole/cable system seems capable of operating on 6m and 4m, so for the moment the dipole is used for 4m, because the 6m reception is quite noisy. The performance is expected to be quite poor on 4 and 6m, but until a better solution is available this will have to do.

The (partly taken down) 4m antenna is now connected to the old cable, running indoors, so a very limited 4m reception is possible, until another 4m(6/10/30m) antenna can be tested. At the moment only a transceiver capable of running a repeater is connected.

For now the 4m will be run on the IC-7300 with the dipole, and 6m on the IC-7600 with the V-2000 vertical.

It looks like the weather will be quite good tomorrow, too, so I may find time for more antenna work.